How To Fix A Bad Epoxy Job

You want to saturate the wood with epoxy wood consolidant so keep going until it is.

Step 5 repair chips. To fix an uneven epoxy finish wait until the epoxy has dried thoroughly and then sand it lightly with fine grained wet sandpaper. Bad mix of epoxy on our part. Apply a light coating of epoxy resin to the specific area to restore sheen.

Now apply a thin epoxy coat and leave it for at least 24 hours. Have you considered using a cabinet scraper and alcohol. Lightly sand the piece that you are working with doing so after the first coat has cured will offer a better second finish. Then just keep your gloves on and pull like crazy.

Oil grease and dirt act as barriers between the substrate and the epoxy which needs to permeate the concrete in order to properly bond. You will find that most resins will level themselves. Sand it down and re poor. How to fix an uneven epoxy finish where surface issues are concerned you will want to keep your resin clear of any particles or debris.

RELATED ARTICLE :

• how to enter radio code honda civic
• how to fall asleep in 120 seconds
• how to end a best man speech

An uneven hardening of your epoxy resin can lead to dull or even tacky spots. Hemlock is right but do not sand the epoxy it turns into a huge mess. Once the duration is completed check the surface to ensure it is not wet or tacky. The epoxy should have hardened enough that you can pry it up.

Wipe the area in circular motions and then buff it. Likewise neglecting to wash away all cleaning agents. After this make sure to wipe down the surface so it is entirely free of any sanding dust and other debris. Then take a clean towel and alcohol and remove the chips with it to see your finish.

Use a disposable paintbrush to work the epoxy into the wood. I ve had the same problem occasionally and use the scraper keeping the work area bathed in alcohol of course this can result in a pleasant buzz so a little fresh air may be a good idea too. Fixing bad epoxy job. Wait overnight or until dried then wipe the entire area with old english lemon oil or a similar product.

Thenuse a chisel and aim for as close as you can to 1 16 from the clear coat top.