How To Clean Mold From Fridge Seal

Many people clean the refrigerator once in a year sometimes never until it gets dirty and full of mold.

Just pour in a sprayer full strength of hydrogen peroxide or vinegar both ingredients are famous for their mold removing properties and spray over the gasket and then wipe that blackened mold with a cloth. Rinse with cold water. Run the cotton swab along the inner creases to be sure the interior gaskets are clean. Rinse with clean water and leave the door open to let the gasket dry.

If mold is on the refrigerator gasket stop it before it becomes a major problem with a few basic cleaning solutions. Use a toothbrush to reach under the gasket and scrub out all the mold that s growing deep in the grooves. Experts advise cleaning the fridge at least once in a year with soapy water or baking soda. The same solution can be used for any mold trace inside the refrigerator.

Wipe the mixture onto the gasket rinse it and dry it. Saturate a cotton swab with vinegar and press it into the gasket folds as well. A safe and effective cleaning solution is to mix 1 quart of warm water with 1 tablespoon of baking soda to clean deodorize and sanitize the gaskets. Allow the spray to sit on the stain for several minutes.

RELATED ARTICLE :

• how to get a job at lululemon
• how to get a lean body male
• how to get a free starbucks drink

You can also mix a tablespoon of baking soda with a quart of warm water to safely clean mold on freezer seal and fridge seal surfaces. Wipe away with a clean cloth. Begin by cleaning the area as normal to remove as much dirt as possible. Scrub along seals with and old toothbrush don t forget the bottom edge rinse well with plain.

Rinse with clean water and wipe dry. Fill the spray bottle with undiluted hydrogen peroxide. Keep the interior dry. To clean your fridge seals use 2parts baking soda one part coarse salt and 1or2 tbl white vinegar.

Cotton swabs can be used to clean out crevices and other nooks. You can use a toothbrush to remove the inaccessible areas. Spray the affect areas. Put full strength hydrogen peroxide or vinegar in a spray bottle spray the gasket then wipe of all the blackening with a clean cloth.

I would leave the door open long enough to let the gasket dry.