How To Fill Nail Holes In Trim

Press the spackling on the knife into one of the nail holes.

Put a small dab of filler onto your index finger. If you are using a joint compound it will shrink as it dries off. Press firmly down on the knife so the spackling completely fills in the nail hole. Use 220grit sandpaper on a sanding block to get it smooth with the rest of the board.

Sand the nail holes. Holes in wood trim are best filled with wood filler. The pressure of the nail gun will cause a mushroom to balloon out of the hole. Purchase a bottle of white craft glue online or from a craft store.

Position the nozzle in front of each nail hole and carefully squeeze in glue until the hole is full. It s best to overfill the hole slightly leaving a slight smooth ridge over the area. For most nail holes the space to fill is so small that it is best to use your finger. Filling nail holes in trim molding with white wood filler all posts door and window casings painting remodeling 101 last week while filling all the nail holes in the plank ceiling crown molding baseboards and window casings and all the trim moulding i ve been installing i ran out of wood filler and when i went to pick some up i found something new new to me anyway.

RELATED ARTICLE :

• how to get better at modern warfare
• how to get beach waves with wand
• how to get beach waves without heat

You can use your finger to push and insert the fillers into the openings. Since the holes are quite small the size of one fourth of a pea is enough to seal a nail hole. Start with the edge of the knife on one side of the hole at a 45 degree angle. You ll remove the primer paint you put on.

Repeat if necessary to fill the hole completely. Nail holes in exterior surfaces just as with cracks or gaps can be dealt with using a good caulking. Squeeze craft glue into nail holes to fill them quickly. Use a wood filler or putty to fill in the holes.

Vacuum dust out of nail holes and wipe down with a slightly damp cloth. Just smear it across until the surface is flat. Scrape the knife across the surface of the hole to the other side.