How To Fix A Broken Door Jamb

Use thin nails to connect the broken parts of the door jamb into the parts that aren t broken.

I ve had to repair many broken door jambs over the years mostly for rental properties and tenants that were careless slammed the door closed with the dead bolt sticking out or had break ins. 6 measure the length and width of the area you just exposed. You will finish repairing your broken door jamb by painting or staining it so it matches the rest of the door. After your repair your broken door jamb you will have a few more steps to get your door looking as good as new.

Unscrew any latch plates chains bolts and other door hardware. Scrape away any small chunks of wood that may be protruding from the door frame. Pull the old rotten doorjamb away from the door and dispose of it. Drill a pilot hole into the door frame.

Step 1 how to fast fix cracked door jamb. A broken door frame doesn t require removal and replacement of the whole thing. Then use a chisel and hammer to pry the door strip away from the door jamb starting from the bottom. Here s how to repair just the split or broken frame area to look as good as.

RELATED ARTICLE :

• how to draw ears on a face
• how to draw a rocket ship easy
• how to draw earth step by step

The easiest way to fix a broken door frame is remove the metal door catch strike and or dead bolt catch strike. Cut a piece of 1 inch thick poplar to fit the opening with a. Start at the bottom of the frame and work your way up. Take care not to damage the stop as you remove it from the frame.

Apply wood filler into the cracks of the door frame. Attach the clamp onto the cracked door frame. Place the claw end of the hammer on the side of each nail to support even removal. To fix the damage around your door knob you will need to repair the wood if possible and install a metal door knob reinforcer.

Use a chisel and hammer or putty knife to pry the door stop and molding away from the frame. Sand the wood filler once it dries and sand the rest of the jamb smooth. As the timber starts to come away put the claw of your hammer on either side of each nail to support the timber as it lifts off. Drill a pilot hole into the door frame.