How To Finish Off A Friendship Bracelet

Take the remaining thread and braid it.

Learn how to finish a bracelet with crimps and covers to finish a bracelet start by putting a crimp bead over your beading wire and then add a clasp. Make one big braid and a knot at the end. Hold all strands together and tie a single knot 3 from the end. Comment down below with your favorite way.

5 braid the ends through the loop if they re long. Divide the strings into two parts and make small braids such as in the pic. How to make a button or bead closure you can also thread a button or a bead on to the end of your bracelet. Changing the raw materials up somewhat will also make these designs suitable for a woman.

Place the knots in each of the holes. Measure to make sure it fits. Hold the bracelet close to the looped end and pull it so that it tightens around the braid. Yes there are other ways to finish friendship bracelets.

RELATED ARTICLE :

• how to cook the perfect medium steak
• how to cook the perfect prime rib
• how to craft a bookshelf in minecraft

An adjustable bracelet is a great handmade gift for a man for his birthday father s day or other occasions the basic instructions for the sliding adjustable knot can be modified for a bracelet or necklace. Start with your almost finished bracelet. After putting the clasp on the wire run the beading wire back through the crimp. One of the simplest ways to finish a friendship bracelet is to divide the strings into two pairs bundles and ply those bundles together to create two twisted ends.

Make a loop with the braided section. Now do the same with the other end of the bracelet. Move the crimp bead up toward the clasp leaving a little room for play in between the clasp and crimp bead. Divide the strings into three parts now.

This video was requested a. Most of the time what i do is at the beginning if the bracelet has a loop at the top i chose one string to be an extra ten inches so at the top before the loop it is five inches higher than the others. These are not all the ways in the world. As you can see there is a small hole at the beginning.

Tape down top of string with washi tape or pin knot to fabric with a safety pin.