How To Drain A Water Heater Fast

Push down a bit on the control so that it will turn.

Extend the life of your water heater with these basic but. To drain your water heater faster the airlock that gets created inside the tank will need to be broken and atmospheric pressure will need to be maintained. This alleviates pressure in the system allowing the water to drain quickly from the tank much like removing your finger from the top of a drinking straw filled with liquid. If using a 5 gallon bucket be prepared to empty it frequently.

Next turn off the water source that supplies the heater with water. The first step on how to drain an electric water heater is to turn off the power button of the heater. Remove the hose from the drain valve and then turn on the heater. Drain the water heater tank open the drain valve which may require loosening the valve with a flathead screwdriver and allow the water to flow until it stops.

Before you shut off the water connect a garden hose to the drain valve and try and flush the water heater tank a bit while the water pressure is on. Open the water valve for 5 minutes to flush out the water heater. To drain your electric water heater take this following step properly. Easy to follow steps for draining your water heater if you have a gas hot water heater turn the burner control knob to pilot.

RELATED ARTICLE :

• how to distress a shirt with bleach
• how to do a turn in dance
• how to do a layup in basketball

There should be an indicator on the face below the knob to confirm your selection. Sediment can collect at the bottom of your water heater so it s important that you run fresh water through it to flush it all out. Try this trick out if you find your water is leaking out too slowly. Opening up your drain pressure relief valve and faucets can all do the trick.

Open a hot water tap nearest to the water heater preferably on the floor above. Here is a quick way to get water out of your water heater. Steps for draining a water heater perform a quick flush. Quickly learn how to drain and flush a hot water heater to remove sediments and prevent corrosion.

Refill the water heater with clean water. To do this you have to disable the circuit breaker or fuse that powers the system. To do this open the drain valve for a few seconds and then close it again.