How To Fix Headphone Wires With Tape

After that cover the whole part with electrical tape make sure wires are not sticking out.

In this video i ll be showing you how to repair headphone wire at home for more videos please subscribed to my channel. That s it your headphones should be working now. If you are into designer stuf get designer tape. Hold a lighter below the tube.

Once completely coated hold over dip and shake off excess liquid still stuck to headphones. Actually the best way to repair this is with tape forget the glue. Remember to keep the insulating tape around the joint to keep the joint firm. Expose them to the wiring and clean them of varnish as well as we did with the aux cable.

Then slide the heat shrinking tubes back down over the covered wires. Continue to wrap the tape around the damaged area directly on top of the first revolution you made. Cut or tear the tape when you complete 2 3 more full wraps and stick the end down. Cover with electrical tape then cover the twisted red wires with electrical tape so they won t be interfering with the copper wires.

RELATED ARTICLE :

• how to download youtube videos to imovie
• how to download live tv on firestick
• how to draw a clone trooper helmet

For soldering it heat the end of the wire using soldering iron. I would suggest a couple of consecutive dips just to ensure a proper coating. Keep it heated as long as the colored varnish has burned off. Separate all wires by colors on these the colors are red green and copper.

Dip just the section of your headphones that you want to apply the coating to and ensure that you completely engulf that section of the wire in the dip. How to fix broken headphone wires with tape. Plastic insulating tape or shrink tubing. Use a wire stripper exact o knife or fingernail clippers will work be carefuler with these though and strip the insulated wires.

Usually the wires of the headphones break right at the exit from the connector and in order to surely cut off the broken part cut off 2 3 cm above the connector. You only need to wrap two of the wires in a thin pre cut piece of electrical tape. I use duct tape and a piece of a wire coat hanger that has been cut and curved as needed to repair them and tape the wire onto the outside of the headphones. Wrap the tape tightly around the wire 2 3 more times and cut it.

Cut the wire with it. Fixing your headphone wires with tape is one of the most convenient solutions.