How To Fix A Stripped Door Hinge

Tap the wooden dowel into 1 of the holes gently using a hammer.

Open the door wide and insert a wedge under the bottom outside corner to level it. Fix it the right way not the wrong way. Once the door hinge is out of the way carefully drill out the hole where the screw used to be. Good evening if howto redditors have a bathroom door with the top hinge screws worked loose but are stripped and will not tighten.

Carefully tap it in with a hammer until it is flush with the surrounding wood. Add glue to the dowels using the brush to spread it evenly around the surface. The wooden dowel will plug the stripped hole essentially giving you a fresh surface to reattach the hinge to. To make sure it stays centered start with 1 8 inch and work your way up.

Remove the screws holding the door hinges to the door and the doorjamb with a phillips screwdriver. After it has dried get a new screw that is not stripped and screw it in the hole that was repaired. A simple method of using golf tees to fix holes that have been stripped out and are to big so the screws will not tighten up the hinge to the door or jamb. Read about how to repair with dowels on the frame side wondering if the same repair can be accomplished door side or is there any other tricks.

RELATED ARTICLE :

• how to find out someone s ip address
• how to find foreclosed homes for sale
• how to find a lost firestick remote

If the hinge and jamb are painted cut the paint around the leaf with a utility knife swing the leaf away from the jamb. Remove the screws that hold the loose hinge leaf to the door jamb. Use your shop brush to spread the glue evenly all around the insides of the holes. How to repair door hinge with stripped screws.

Give the hole time to dry before you replace the screws and hinge. How to repair a loose screw in a door hinge or cabinet most of the time a loose screw appears on things that move a lot. Add glue to the holes. Pick a bit slightly smaller than the insert width for a tight fit.

Set the door on its side with the hinge. Doors both hinges and locks kitchen and bathroom cabinets and just about anything else that is subject to movement or vibration. Have a helper hold the door up as you remove the hinges. After you have done that put them in the hole that is stripped.

The wrong way is a temporary fix not cool. Compare the drill bit width to the size of the insert to find which bit size to stop at.