How To Drill Holes In Terracotta Pots

These containers can be found either glazed or left in their natural state.

Terracotta clay mudpot holes in terracotta. Audrey s little farm videos. Many of the ceramic containers intended for plants are made from soft terracotta clay. Once the pot is saturated place a piece of tape over the spot you plan to drill through to prevent the drill bit from slipping.

Once you ve hit your max angle the drill again and keep digging down. You can only drill normally as deep as your initial 90 angle depth. Then start the drill at a low speed. Center your drill bit so that your hole will be in the center.

The drill bit will do everything as long as you keep it in contact with the surface of the pot. Drilling holes in terracotta pots 20 04 2007 11 38 am. Increase the drill speed while maintaining the same position on the pot. Be sure that the pot is set somewhere where it is secure and won t move as you start to drill.

RELATED ARTICLE :

• how to cook haddock on the grill
• how to cook shrimp with old bay
• how to cook pre smoked turkey wings

Some pots planters are super thick and will take some time to get through. Https youtu be p1h9n6bo7ai holes in ceramic. Set your pot upside down so that you are drilling from the outside in. Place the bit above where you want the hole to be and pull the trigger.

The key to properly drill drainage holes is using the correct drill bit. Some are thinner or softer like terracotta and won t take much time at all. Get the cooling water set up. Thought you might like to see how i went on i managed to drill a small hole in the pot without cracking it by using 2 different size drill bits starting with a smaller one resting the pot in a bag of compost.

Both can be drilled though pottery in it natural state is by far the easiest. If you are using a set of drill bits start with the smallest one.