How To Cover Nail Holes In Wall

There are a multitude of diy ways to fill nail holes.

If you have a larger hole to deal with concealing it with a picture or furniture is likely your best bet. Albert uses minwax stain markers. Grab a small glob of spackle that is just larger than the hole you want to fill. Allow the area to dry then sand lightly.

When painting walls put aside a small labeled can or bottle to keep on hand as touch up paint. Start by removing the nail or screw from the wall and be sure to remove the anchor as well if there is one. The amount of work it takes to fill nail holes depends on the size and shape of the holes themselves. Use a putty knife to fill them with spackling or wall joint compound.

As you might be able to guess a small hole such as one left over from a 4x6 framed print is going to be a touch easier to deal with then the larger holes left over from heavy shelves that had to be studded into the wall. Try your best to get the layer of glue as flush with the wall as possible once the glue hardens you d have to chip off the excess glue to create an even layer. Open up the tub of wall spackle and dip the end of your putty knife into it. If you have a smaller hole in the wall to fill apply a bit of elmer s glue to the hole with a q tip.

RELATED ARTICLE :

• how to fix a clogged kitchen sink
• how to fix a dented garage door
• how to fix a leaking toilet bowl

It s always best to actually fix a hole in the wall but you do have options if you re desperate for a temporary way to patch or cover a hole for nail holes household items like toothpaste and soap can offer short term solutions. They touch up patches and nicks until you deck the halls again. Fix tiny nail and screw holes. Fix holes between 1 2 and 11 2 in.

Tackle nail holes on wooden doors and paneled walls much the same way. Place the putty knife right above the hole and drag it downward to apply the spackle focusing on the hole with about 0 25 inches 0 64 cm of spackle around it. Tiny nail and screw holes are the easiest to fix. From there paint right over the area to create a uniform surface.

Use the cap of the 4 in 1 patch plus primer to very lightly sand down the wall to remove any paint or drywall flakes. Patching small drywall holes. Anything larger must be covered with a bridging material for strength before patching compound can be applied. If you are moving into a home with holes chances are pretty good that you want these holes filled properly.